GATE Mechanical Exam Sample Question Papers

Will you please provide me question paper for GATE Mechanical Examination as soon as possible?

Here I am giving you question paper for GATE Mechanical Examination in PDF file attached with it so you can get it free of cost ..

Q.4 During normalizing process of steel, the specimen is heated
(A) between the upper and lower critical temperature and cooled in still air.
(B) above the upper critical temperature and cooled in furnace.
(C) above the upper critical temperature and cooled in still air.
(D) between the upper and lower critical temperature and cooled in furnace.

Q.5 Oil flows through a 200 mm diameter horizontal cast iron pipe (friction factor, f = 0.0225) of
length 500 m. The volumetric flow rate is 0.2 m3/s. The head loss (in m) due to friction is (assume
g = 9.81 m/s2)
(A) 116.18 (B) 0.116 (C) 18.22 (D) 232.36
Q.6 For an opaque surface, the absorptivity    , transmissivity    and reflectivity    are related by
the equation:
(A)      (B) 0       (C) 1     (D) 0    

Q.7 Steam enters an adiabatic turbine operating at steady state with an enthalpy of 3251.0 kJ/kg and
leaves as a saturated mixture at 15 kPa with quality (dryness fraction) 0.9. The enthalpies of the
saturated liquid and vapor at 15 kPa are hf = 225.94 kJ/kg and hg = 2598.3 kJ/kg respectively. The
mass flow rate of steam is 10 kg/s. Kinetic and potential energy changes are negligible. The power
output of the turbine in MW is
(A) 6.5 (B) 8.9 (C) 9.1 (D) 27.0

Q.15 A CNC vertical milling machine has to cut a straight slot of 10 mm width and 2 mm depth by a
cutter of 10 mm diameter between points (0, 0) and (100, 100) on the XY plane (dimensions in mm).
The feed rate used for milling is 50 mm/min. Milling time for the slot (in seconds) is
(A) 120 (B) 170 (C) 180 (D) 240

Q.16 A solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies
to a height of 25 mm. The percentage change in diameter is
(A) 0 (B) 2.07 (C) 20.7 (D) 41.4

Q.30 An incompressible fluid flows over a flat plate with zero pressure gradient. The boundary layer
thickness is 1 mm at a location where the Reynolds number is 1000. If the velocity of the fluid
alone is increased by a factor of 4, then the boundary layer thickness at the same location, in mm
will be
(A) 4 (B) 2 (C) 0.5 (D) 0.25

Q.31 A room contains 35 kg of dry air and 0.5 kg of water vapor. The total pressure and temperature of
air in the room are 100 kPa and 25°C respectively. Given that the saturation pressure for water at
25°C is 3.17 kPa, the relative humidity of the air in the room is
(A) 67% (B) 55% (C) 83% (D) 71%

Attached Files Available for Download

	GATE Mechanical Exam paper -1.pdf (119.0 KB, 34 views)
	GATE Mechanical Exam paper.pdf (335.1 KB, 69 views)

__________________
Answered By StudyChaCha Member