Go Back   StudyChaCha 2024 2025 > StudyChaCha Discussion Forum > General Topics

  #2  
Old January 14th, 2014, 12:18 PM
Super Moderator
 
Join Date: Jun 2013
Default Re: Last year Paper for GATE Electrical Engineering

Here I am giving you question paper for the electrical engineering GATE examination in PDF file attached with it so you can get it easily..

Some question are given below :
Q.10 The slip of an induction motor normally does not depend on
(A) rotor speed (B) synchronous speed
(C) shaft torque (D) core-loss component

Q.13 The bridge method commonly used for finding mutual inductance is
(A) Heaviside Campbell bridge (B) Schering bridge
(C) De Sauty bridge (D) Wien bridge

Q.19 The output Y of a 2-bit comparator is logic 1 whenever the 2-bit input A is greater than the 2-bit
input B. The number of combinations for which the output is logic 1, is
(A) 4 (B) 6 (C) 8 (D) 10

Q.24 The typical ratio of latching current to holding current in a 20 A thyristor is
(A) 5.0
(B) 2.0
(C) 1.0
(D) 0.5

Q.34 A cylindrical rotor generator delivers 0.5 pu power in the steady-state to an infinite bus through a
transmission line of reactance 0.5 pu. The generator no-load voltage is 1.5 pu and the infinite bus
voltage is 1 pu. The inertia constant of the generator is 5 MW-s/MVA and the generator reactance
is 1 pu. The critical clearing angle, in degrees, for a three-phase dead short circuit fault at the
generator terminal is
(A) 53.5 (B) 60.2 (C) 70.8 (D) 79.6

Q.45 An analog voltmeter uses external multiplier settings. With a multiplier setting of 20 kWit reads
440 V and with a multiplier setting of 80 kWit reads 352 V. For a multiplier setting of 40 kW the
voltmeter reads
(A) 371 V (B) 383 V (C) 394 V (D) 406 V

Q.46 The locked rotor current in a 3-phase, star connected 15 kW, 4-pole, 230 V, 50 Hz induction motor
at rated conditions is 50 A. Neglecting losses and magnetizing current, the approximate locked
rotor line current drawn when the motor is connected to a 236 V, 57 Hz supply is
(A) 58.5 A (B) 45.0 A (C) 42.7 A (D) 55.6 A

Q.47 A single phase 10 kVA, 50 Hz transformer with 1 kV primary winding draws 0.5 A and 55 W, at
rated voltage and frequency, on no load. A second transformer has a core with all its linear
dimensions 2 times the corresponding dimensions of the first transformer. The core material and
lamination thickness are the same in both transformers. The primary windings of both the
transformers have the same number of turns. If a rated voltage of 2 kV at 50 Hz is applied to the
primary of the second transformer, then the no load current and power, respectively, are
(A) 0.7 A, 77.8 W (B) 0.7 A, 155.6 W (C) 1 A, 110 W (D) 1 A, 220 W

For more details I am attaching a PDF file with it so you can get it easily..
Attached Files Available for Download
File Type: pdf GATE EE question paper.pdf (325.4 KB, 35 views)
__________________
Answered By StudyChaCha Member
Reply With Quote
  #3  
Old September 29th, 2015, 04:40 PM
Unregistered
Guest
 
Default Re: Last year Paper for GATE Electrical Engineering

I am sapna a four year b tech JECRC JAIPUR student of electrical department I am preparing for gate exam and want last year paper for GATE exam Electrical department ?
Reply With Quote
  #4  
Old September 29th, 2015, 04:45 PM
Super Moderator
 
Join Date: Jun 2013
Default Re: Last year Paper for GATE Electrical Engineering

Hi sapan here I am providing some question along with the last year paper

1 Which of the following options is the closest in meaning to the phrase underlined in the sentence below?
It is fascinating to see life forms cope with varied environmental conditions.
(A) adopt to (B) adapt to (C) adept in (D) accept with

2 Choose the most appropriate word from the options given below to complete the following
sentence.
He could not understand the judges awarding her the first prize, because he thought that her
performance was quite __________.
(A) superb (B) medium (C) mediocre (D) exhilarating

3 In a press meet on the recent scam, the minister said, "The buck stops here". What did the minister convey by the statement?
(A) He wants all the money (B) He will return the money
(C) He will assume final responsibility (D) He will resist all enquiries

4 The Palghat Gap (or Palakkad Gap), a region about 30 km wide in the southern part of the Western Ghats in India, is lower than the hilly terrain to its north and south. The exact reasons for the formation of this gap are not clear. It results in the neighbouring regions of Tamil Nadu getting more rainfall from the South West monsoon and the neighbouring regions of Kerala having higher summer temperatures. What can be inferred from this passage?
(A) The Palghat gap is caused by high rainfall and high temperatures in southern Tamil Nadu and Kerala
(B) The regions in Tamil Nadu and Kerala that are near the Palghat Gap are low-lying
(C) The low terrain of the Palghat Gap has a significant impact on weather patterns in neighbouring parts of Tamil Nadu and Kerala
(D) Higher summer temperatures result in higher rainfall near the Palghat Gap area

5 Geneticists say that they are very close to confirming the genetic roots of psychiatric illnesses such as depression and schizophrenia, and consequently, that doctors will be able to eradicate thesediseases through early identification and gene therapy.
On which of the following assumptions does the statement above rely?
(A) Strategies are now available for eliminating psychiatric illnesses
(B) Certain psychiatric illnesses have a genetic basis
(C) All human diseases can be traced back to genes and how they are expressed
(D) In the future, genetics will become the only relevant field for identifying psychiatric illnesses

6 Round-trip tickets to a tourist destination are eligible for a discount of 10% on the total fare. In
addition, groups of 4 or more get a discount of 5% on the total fare. If the one way single person
fare is Rs 100, a group of 5 tourists purchasing round-trip tickets will be charged Rs

GATE Electrical-Engineering-2014-set-1





Attached Files Available for Download
File Type: pdf GATE Electrical-Engineering-2014-set-1.pdf (527.1 KB, 34 views)
File Type: pdf GATE Electrical-Engineering-2014-set-2.pdf (476.7 KB, 20 views)
File Type: pdf GATE Electrical-Engineering-2014-set-3.pdf (509.4 KB, 19 views)
__________________
Answered By StudyChaCha Member
Reply With Quote
Reply




All times are GMT +6. The time now is 01:58 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Search Engine Friendly URLs by vBSEO 3.6.0 PL2

1 2 3 4 5 6 7 8