PTU B. Tech Civil Engineering-5th Semester- Design of Steel Structures (CE-303) Previ

Can you provide me the PTU B. Tech Civil Engineering-5th Semester- Design of Steel Structures (CE-303) Previous Years Question Papers???

This is the PTU B. Tech Civil Engineering-5th Semester- Design of Steel Structures (CE-303) Previous Years Question Papers:

What are various modes of failure-Ofa riveted joint?
Q3) A 8mm thick angle section is joined to a 10mm thick gusset plate. Angle is .-
supportinga loadof70 kN. Find out number of 18mmdiameterrivets required
for the connection.
Q4) A tie member 100x8mm is to transmit a load of 115 kN. Design the fillet
weld and calculate necessary overlap if (i) welding is done on three sides

Q5) Design a tension member to transmit a pulLof 150kN. Effective length of
member is 4.5 meters. Member should consist of a pair of angles connected
to both sides of gusset plate.

Q6) Give, in detail, various loads considered for the design of Roof Trusses.






Address
Punjab Technical University
Near Pushpa Gujral Science City, Jalandhar- Kapurthala Hwy, Rasulpur, पंजाब 144601 ‎
0182 266 2521

As you are looking for the PTU B. Tech Civil Engineering-5th Semester- Design of Steel Structures question paper so here it is given below

Duration of the test: 3 hours

Maximum marks: 60

In Section A there are 10 objective questions, each question carries 2 marks.

In Section B there are five questions out of which four are to be attempted. Each question carries 5 marks.

Section C consists of three questions, students have to attempt 2. Each of the questions is of 10 marks.

PTU B. Tech Civil Engineering-5th Semester- Design of Steel Structures Paper

__________________
Answered By StudyChaCha Member