National Power Training Institute (NPTI) Question Paper of PGDC

Will you please share the Model Question paper of Post Graduate Diploma Course (PGDC) - Common Entrance Test conducted by National Power Training Institute (NPTI)???

National Power Training Institute (NPTI) conducts Post Graduate Diploma Course (PGDC) - Common Entrance Test

Here I am sharing the Post Graduate Diploma Course (PGDC) - Common Entrance Test Model Question paper of National Power Training Institute (NPTI)

Q1. to Q30 Part-I. General Aptitude (common)
Q1. If TEST is to be coded as SERT then STUDENT is to be coded as
i. RTUCDMS
ii. RTTDDNV
iii. RTTDDNS
iv. SSUCEMT
Q2. What is the smallest number that may be added to make 899 a perfect cube
root?
i. 71
ii. 101
iii. 171
iv. 1
Q3. At what price a car is to be sold to get 20% gain If its purchase price is of Rs.
80,000/- ?
i. Rs. 92000
ii. Rs. 96000
iii. Rs. 64000
iv. Rs. 95000
and so on

Q31. to Q60. General Engineering/Science (Common)
Q31. 1 Horse power(HP) is equal to
i. 726 Watts
ii. 736 Watts
iii. 746 Watts
iv. 732 Watts
Q32. The function of a fuse in an electrical circuit is to
i. heat up
ii. protect by opening circuit
iii. sort by melting the circuit
iv. fuse for formation of alloy
Q33. For proper combustion, the following materials are required
i. proper fuel
ii. adequate air
iii. heat
iv. all the above
and so on.

PART-II
Q61. to Q120 Model question paper (Mechanical Specialization)
Q61. A perfect engine works on the Carnot cycle between 1000degree
centigrade and 200 degree centigrade. The efficiency of the engine will be
i. 80%
ii. 60%
iii. 62.8%
iv. 37.2%
Q62. At critical point the enthalpy of vaporization is
v. zero
vi. Minimum
vii. Maximum
viii. Unpredictable
Q63. When a strip made of iron and copper is heated
i. It gets twisted
ii. Iron bends on convex side
iii. Iron bends on concave side
iv. The strip breaks away
And so on

PART-II
Q61. to Q120 Model question paper (Electrical Specialization)
Q61. The percent regulation of the alternator at unity power factor is
i. 1.05
ii. 10.5
iii. 21.5
iv. 27.5
Q62. Zero power factor method of an alternator is used to find its
i. field resistance
ii. armature resistance
iii. efficiency
iv. voltage regulation
Q63. An induction motor is
i. self-starting with zero torque
ii. self-starting with high torque
iii. self-starting with small torque as compared to rated torque
iv. assisted starting with zero torque
and so on

PART-II
Q61. to Q120 Model question paper (Electronics/Electronics &
Communication / Instrumentation Specialization)
Q61. The intrinsic strand off ratio (η)of a UJT lies between
i. zero
ii. Greater than 1
iii. 0.5 < η< 1
iv. 0 < η< 0.5
Q62. In a single phase dual converter, α1 and α2 are firing angles of the two
converters. Then
i. α1-α2 = π/2
ii. α1+α2 = π
iii. α1-α2 = π
iv. α1+α2 = π/2
Q63. Microwave antenna aperture efficiency depends on
i. Feed pattern
ii. Low side lobe levels
iii. Surface losses
iv. Antenna aperture
and so on


Address:
National Power Training Institute
Badarpur Village, Badarpur, New Delhi, DL 110044 ‎
011 2694 7043 ‎

Map: